• DO NOT vacuum with a frayed, worn, or damaged cord. • DO NOT vacuum liquids or expose the vacuum to rain or water. The vacuums in this manual are for dry use only and are not to be used or stored outdoors in wet conditions.
Page 5
Check with a qualified electrician or service person if you doubt that the outlet is properly earthed (grounded). Do not modify the plug provided with the vacuum. If it will not fit the outlet, have a proper outlet installed by a qualified electrician.
ProTeam distributor for inspection. DO NOT pull or carry the vacuum by the cord or use the cord as a handle. Do not close a door on the cord or pull the cord around sharp edges or corners.
The power supply cord at the vacuum c. That the switch is in the “ON” position and functioning properly If the exhaust that comes out of the bottom of the vacuum is warmer than usual, check and clean all four filters.
This warranty is extended only to the original purchaser of the vacuum cleaner. If the vacuum cleaner is found to be defective during the warranty period, it will be ProTeam’s option to replace or repair it,...
• DO NOT vacuum with a frayed, worn, or damaged cord. • DO NOT vacuum liquids or expose the vacuum to rain or water. The vacuums in this manual are for dry use only and are not to be used or stored outdoors in wet conditions.
Page 10
ELECTRICAL The vacuum as described in this manual, unless otherwise noted, are designed to operate on 110V – 120V ~ power supply at 400Hz. The vacuum as described in this manual is a Class I appliance. The vacuum cleaner described in this manual is equipped with a thermal protection device.
ProTeam distributor for inspection. DO NOT pull or carry the vacuum by the cord or use the cord as a handle. Do not close a door on the cord or pull the cord around sharp edges or corners.
50 feet at 16 gauge or 100 feet at 14 gauge. Longer cords will overheat and damage the vacuum. If the exhaust that comes out of the bottom of the vacuum is warmer than usual, check and clean all four filters.
Page 13
ProTeam, its service agent, or similarly qualified persons in order to avoid a hazard. PROPER STORAGE When the vacuum is not in use, the vacuum and extension cord, if applicable, should be stored indoors and in a dry place. ProTeam...
This warranty is extended only to the original purchaser of the vacuum cleaner. If the vacuum cleaner is found to be defective during the warranty period, it will be ProTeam’s option to replace or repair it,...
Figure C Figure D Figure E GETTING STARTED 1. Unscrew the cap on the top of the vacuum unit (Figure A). 2. Remove filters (Figure B). 3. Check to make sure the Dome Filter did not shift during shipping (Figure C).
Figure K BACKPACK ERGONOMICS • The weight of the vacuum should be evenly distributed on your hips. • Adjust the padded waist belt and shoulder straps for a custom fit. • The backpacks have a ventilated backplate to keep the operator cool.
(Figure R). The motion is similar to mopping and keeps the upper body and arms from tiring. OPERATING THE BACKPACK VACUUM 13. Thread the extension cord through the Cord-O-Holder on the waistbelt (Figure L).
(Figure X). 6. Following the above instructions is the best way to prolong the life of the vacuum. DO NOT TRY TO WASH or VACUUM the LineVacer HEPA, ULPA or QuietPro BP and QuietPro CN HEPA Exhaust Filters.
Motor Compression Ring w/Screws 100378 Compression Ring Screw Set: 4 Screws 100014 Tetraseal 100173 Carbon Brush Set for 400 Hz Motor (AviationVac) 100171 Motor/Fan w/Rectifier and Crimps (400Hz) (AviationVac) 100174 Motor Rectifier (AviationVac) 100379 Motor Ground Connection and Wire Clamp Set w/Screws...