Ptx_Setup Commands To Activate Ucp (Version 2.0); Ptx_Setup Commands To Activate Pxml - Printronix SL4M Reference Manual

Chapter 2
PXML Selection

PTX_SETUP Commands To Activate UCP (Version 2.0)

This sets up UCP using the Ethernet port on port number 3007 for version 2.0
and above:
!PTX_SETUP
CONFIG-MPI_SELECT;UCP
CONFIG-PNE_PORT;ETHERNET
CONFIG-PNE_PORT_NUM;3007
PTX_END

PTX_SETUP Commands To Activate PXML

This section defines PTX_SETUP commands that are used to activate PXML.
The default setting on printers with PXML version 2.0 and above is "PXML
enabled" on port 3007.
These commands are:
CONFIG-MPI_SELECT;value
where values are:
CONFIG-PNE_PORT;value
where values are:
CONFIG-PXML_PORT;value
Where values are:
CONFIG-PNE_PORT_NUM;value
where value selects the active PNE Port Number.
NOTE: The printer automatically reboots after this command.
CONFIG-PXML_PORT_NUM;value
where value selects the active PXML Port Number.
NOTE: The printer automatically reboots after this command.
10
PNE (For version 1.0)
UCP (For version 2.0 and above)
PXML
DISABLE
ETHERNET (if Ethernet is not available, try Adapter if it is
enabled)
DISABLE
ETHERNET (if Ethernet is not available, try Adapter if it is
enabled)