Adjusting The Tray Speed - Primera Accent II User Manual

TOC
C. TROUBLESHOOTING (continued)
Problem
There is a disc jammed in
my Laminator - the tray
has stalled.
D. ADJUSTING THE TRAY SPEED
Adjusting the tray speed is a handy trouble shooting step if
your media is not laminating consistently. You can easily
adjust the tray speed in one of two ways:
Via the Temperature Slide Bar.
1. Power off the Laminator. Slide the temperature bar to
the far left to set the tray speed to its slowest setting, to
the far right for the fastest speed setting or somewhere
in between. (There are six tray speed settings from 1 - 2
inches per second - Default is 1.5) Once you have the
slide bar in the desired location, press the laminate
button as you turn on the laminator.
Via the Print Driver.
2. Go to Start - Control Panel - Printers and Faxes - Right
Click on the Disc Laminator - Choose Printing
Preferences. Click Properties next to Lamination Speed.
Decrease or Increase the tray speed accordingly. (From 1
- 2 inches per second - Default is 1.5) You would have
installed the Driver if you have purchased one of the
Laminator stands for a Composer XL/Pro/Max
duplicators. If you have not installed the driver
you can download it here:
www.primera.com/primera_printer_drivers.html
Once you have downloaded the driver you will need to
connect the laminator to the computer with a standard
USB cable. A driver installation wizard will appear.
Finish the wizard to install the driver.
12 Maintenance and Troubleshooting
Resolution
Most likely the disc is not seated
•
properly in the tray. Clear the jam
by opening the top cover, and
removing the disc from the
laminator. If the Overlaminate
film has torn, it can be reattached
to the supply roll. Once the jam
has been cleared, close the cover
and press the Laminate button;
the job will continue.
INDEX