Preparation; Unpacking The Tv - JVC LT-32C655 Instruction Manual

Chapter
2

Preparation

2
Thank you
Your new TV has many features and incorporates the latest technology to enhance your viewing
experience. We recommend that you spend some time reading this instruction manual so that you fully
understand these features. You will also find some hints and tips to help you resolve any issues.
Read all the safety instructions carefully before use and keep this instruction manual for future reference.

Unpacking the TV

Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.
The following items are included:
TV
TV Stand
Instruction Manual
32" LED Smart HD TV
with built-in DVD player
LT-32C655
For help and support call
UK: 0344 561 1234 • Ireland: 1890 818 575
Instruction Manual
8
LT-32C655_IB.indd 8
for purchasing your new JVC TV.
Wi-Fi Dongle and Extender
GB
Quick Start Guide
32" LED
Smart HD TV
with built-in DVD player
LT-32C655
Thank you
for purchasing your new JVC TV.
Your new TV incorporates the latest technology to enhance your
viewing experience. We would suggest that you allow about 20
mins for initial setup. If you need help setting up your TV then please call:
Please follow this guide for a successful first time installation. UK: 0344 561 1234
Ireland: 1890 818 575
The latest eco-friendly power-saving technology will switch
off the TV if it is left on and idle for 4 hours. Please refer to
"Auto Standby" under the "Time Settings" section of the
instruction manual for more detail.
1
Unpacking
Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.
TV Remote Control/
AAA Batteries x2
TV Stand
Screws x 4
Wi-Fi Dongle + Extender
YPbPr Cable
Please inspect your TV for damage after unpacking. If you do notice any damage please consult your dealer.
2
Operating Your Remote Control
1. Slide open the battery compartment on the back of the remote control.
2. Insert two AAA size batteries. Make sure to match the (+) and ( - )
ends of the batteries with the (+) and ( - ) ends indicated in the battery
compartment.
3. Slide the battery compartment cover back into place. Make sure it clicks
into place.
LT-32C655_QSG.indd 1
Quick Start Guide
Stand screws x4
3 Installing the TV Stand
1. Ensure the TV is switched off and not connected to the
mains power supply.
2. Lay the TV down on a flat surface ideally on the edge of a
table so the base of the TV slightly overhangs the edge of
the table, with the back side facing up. Please make sure a
soft cushioned material (such as a dry bath towel or thick LAN
piece of foam) is placed beneath the screen.
SPDIF VGA
Coax.OUT
SCART
Cushioned
Table
material
TV stand (supplied)
3. Slide the stand under the lip, the neck will fit snugly over
Need More Help!
the screw holes. Then screw the stand to the TV using the
4 screws supplied.
Lines are open 24/7
The LCD display is very fragile, and must be protected at
all times when installing and removing the base stand. Be Slide under
sure that no hard or sharp object, the lip
or anything that could scratch or damage the LCD display,
comes into contact with it. DO NOT exert pressure on the
front of the TV at any time because
the screen could crack.
4
FAV Cable Connecting the Aerial, Wi-Fi Dongle and Turning on the TV
Instruction Manual
Quick Start Guide
1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the ANT socket on the back of your TV.
2. Connect the Wi-Fi dongle to one of the USB sockets on the back of your TV.
3. Plug the TV into a mains socket and switch on at the mains.
4. In standby mode, press the button on the remote control to turn the TV on. The LED indicator will flash for a few seconds then the TV will switch on.
Optional - If you want to connect to the internet via a wired connection then connect your ethernet cable to the LAN socket.
LAN
SPDIF VGA USB
LAN RF coaxial cable LAN Max. 500mA 5Vdc
SPDIF VGA Coax.OUT (not included) VGA SPDIF USB
Coax.OUT SCART Coax.OUT SCART
Max. 500mA 5Vdc
SCART
• Do not connect the TV to the mains supply until you have completed all the connections.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.
To completely disconnect the mains power, please remove the mains plug from the mains socket.
17/04/2015 17:33
Remote Control /
AAA Batteries x 2
FAV Cable
Slide under
the lip
YPbPr Cable
17/04/2015 17:35