Preparation; Unpacking The Tv - JVC LT-32C666A Instruction Manual

32" led smart hd tv with built-in dvd player
Table of Contents

Advertisement

Chapter
2

Preparation

2
Thank you
Your new TV has many features and incorporates the latest technology to enhance your viewing
experience. We recommend that you spend some time reading this instruction manual so that you fully
understand these features. You will also find some hints and tips to help you resolve any issues.
Read all the safety instructions carefully before use and keep this instruction manual for future reference.

Unpacking the TV

Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.
The following items are included:
TV
TV Stand
Instruction Manual
32" LED Smart HD TV
with built-in DVD player
LT-32C666(A)
Instruction Manual
10
LT-32C666(A)_IB.indd 10
for purchasing your new JVC TV.
GB
Quick Start Guide
32" LED Smart HD TV
with built-in DVD player
LT-32C666(A)
Thank you
for purchasing your new JVC TV.
Your new TV incorporates the latest technology to enhance
your viewing experience. We would suggest that you allow
about 20 mins for initial setup.
Please follow this guide for a successful first time installation.
The latest eco-friendly power-saving technology will
switch off the TV if it is left on and idle for 4 hours. Please
refer to "Auto Standby" under the "Time Settings" section
of the instruction manual for more detail.
1
Unpacking
Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.
TV
Remote Control/
FAV Cable
AAA Batteries x2
TV Stand
Instruction Manual
Screws x 4
Quick Start Guide
Please inspect your TV for damage after unpacking. If you do notice any damage please consult your dealer.
2
Operating Your Remote Control
1. Slide open the battery compartment on the back of the remote control.
2. Insert two AAA size batteries. Make sure to match the (+) and ( - )
ends of the batteries with the (+) and ( - ) ends indicated in the battery
compartment.
3. Slide the battery compartment cover back into place. Make sure it clicks
into place.
LT-32C666(A)_QSG.indd 1
Quick Start Guide
Stand screws x4
SIDE AV Cable
3
Installing the TV Stand
1. Ensure the TV is switched off and not connected to the
mains power supply.
2. Lay the TV down on a flat surface ideally on the edge of a
table so the base of the TV slightly overhangs the edge of
the table, with the back side facing up. Please make sure a
soft cushioned material (such as a dry bath towel or thick
LAN
piece of foam) is placed beneath the screen.
SPDIF
VGA
Coax.OUT
SCART
Slide under
the lip
Cushioned
Table
material
TV stand (supplied)
3. Slide the stand under the lip, the neck will fit snugly over
the screw holes. Then screw the stand to the TV using the
4 screws supplied.
The LCD display is very fragile, and must be protected at
all times when installing and removing the base stand. Be
Slide under
sure that no hard or sharp object,
the lip
or anything that could scratch or damage the LCD display,
comes into contact with it. DO NOT exert pressure on the
front of the TV at any time because
the screen could crack.
4
Connecting the Aerial and Turning on the TV
1. Connect one end of the RF coaxial cable to the aerial socket on the wall
and the other end of the cable to the ANT socket on the back of your TV.
Optional
2. Plug the TV into a mains socket and switch on at the mains.
If you want to connect to the internet via a wired connection
3. In standby mode, press the
button on the remote control to turn the
then connect your ethernet cable to the LAN socket.
TV on. The LED indicator will flash for a few seconds then the TV will
switch on.
LAN
VGA
SPDIF
LAN
SPDIF
VGA
Coax.OUT
Optic.OUT
RF coaxial cable
SCART
(not included)
SCART
• Do not connect the TV to the mains supply until you have completed all the connections.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.
To completely disconnect the mains power, please remove the mains plug from the mains socket.
14/11/2016 12:47
2
3
.,/@
ABC
DEF
4
5
6
GHI
JKL
MNO
7
8
9
PQRS
TUV
WXYZ
0
TV
V
P
OK
EPG
TXT
LANG.
SUBT.
Remote Control /
AAA Batteries x 2
15/11/2016 11:06

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lt-32c666

Table of Contents