Installing / Removing The Base Stand; Fitting The Stand To The Tv - JVC LT-32C655 Instruction Manual

Installing / Removing the Base Stand

The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that
no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert
pressure on the front of the TV at any time because the screen could crack.

Fitting the Stand to the TV

1. Ensure the TV is switched off and not
connected to the mains power supply.
2. Lay the TV down on a flat surface
ideally on the edge of a table so the
base of the TV slightly overhangs the
edge of the table, with the back side
facing up. Please make sure a soft
cushioned material (such as a dry bath
towel or thick piece of foam) is placed
beneath the screen.
3. Slide the stand under the lip, the neck
will fit snugly over the screw holes.
Then screw the stand to the TV using
the 4 screws supplied.
LAN
VGA
SPDIF
Coax.OUT
SCART
LT-32C655_IB.indd 9
Table
TV Stand (supplied)
Preparation
LAN
VGA
SPDIF
Coax.OUT
SCART
Cushioned
material
Slide under
the lip
2
9
17/04/2015 17:35