Toro 414158000 Operator's Manual page 10

Mower with 52in or 60in turbo force cutting unit and low flow hydraulics
Table of Contents

Advertisement

Power-Takeoff Switch (PTO)
Use the power-takeoff switch (PTO) to engage and
disengage mower blades or start and stop powered
attachments
(Figure
4); refer to
Power-Takeoff (PTO) Switch (page
Hour Meter
The hour meter records the number of hours the
engine has operated. It operates when the engine
is running. Use these times for scheduling regular
maintenance
(Figure
5).
1. Safety-interlock symbols
2. Battery light
Safety-Interlock Indicators
Symbols on the hour meter indicate with a black
triangle that the interlock component is in the correct
position
(Figure
5).
Battery-Indicator Light
If you turn the key to the O
seconds, the battery voltage displays in the area
where the hours are normally displayed.
The battery light turns on when you turn the key to the
O
position and when the charge is below the correct
N
operating level
(Figure
Throttle Control
The throttle controls the engine speed, and it has a
continuous-variable setting from the S
position
(Figure
4).
Key Switch
The key switch, used to start and shut off the engine,
has 3 positions: O
, R
FF
Operating the Ignition Switch (page
Operating the
15).
Figure 5
3. Hour meter
position for a few
N
5).
to F
LOW
, and S
. Refer to
UN
TART
16).
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction
Fuel-Shutoff Valve
Close the fuel-shutoff valve when transporting or
storing the machine; refer to
Valve (page
Accessory Frame
Use the accessory frame to attach only Toro-approved
accessories to the machine
Operator's Manual for the accessory for installation
instructions.
Accessory-Frame Lock
The accessory-frame lock holds the frame in place on
the machine using the lock pin. Always lock the frame
unless a hydraulic kit is installed with an accessory
on the machine
g216020
Adjustable Casters
When using the machine without an accessory, place
the adjustable casters in the mowing position (front
hole) as shown in
with an accessory, refer to the Operator's Manual for
that accessory for the correct caster position.
1. Mowing position
AST
10
Using the Fuel-Shutoff
23).
(Figure
(Figure
3).
Figure
6. When using the machine
Figure 6
Right Caster Shown
2. Accessory positions
(Figure
4).
3). Refer to the
g033081

Advertisement

Table of Contents
loading

Table of Contents