Table of Contents
Advertisement
Maintenance Service
Interval
Every 100 hours
Every 150 hours
Every 200 hours
Every 300 hours
Every 500 hours
Every 600 hours
Every 800 hours
Every 1,000 hours
Before storage
Yearly
Important:
Refer to your engine owner's manual for additional maintenance procedures.
Pre-Maintenance
Procedures
Using the Cylinder Lock
1.
Park the machine on a level surface, disengage
the PTO, move the motion-control levers to
the NEUTRAL-LOCK position, and engage the
parking brake.
2.
Raise the A-frame.
3.
Shut off the engine and remove the key.
4.
Install the cylinder lock over the cylinder rod
using the pin and hairpin cotter.
Maintenance Procedure
• Change the engine oil.
• Check the battery.
• Check the clutch.
• Check and clean the engine cooling fins and shrouds (more often in dirty or dusty
conditions).
• Check the mower-deck belt(s).
• Inspect the primary filter and the air-inlet screen.
• Change the engine-oil filter.
• Check, clean and gap the spark plug.
• Grease the engine voltage regulator. (More often if grease is not present.)
• Replace the primary air filter (more often in dirty or dusty conditions).
• Check the inner air filter (more often in dirty or dusty conditions).
• Apply anti-sieze compound to the platform knobs.
• Adjust the caster-pivot bearing.
• Change the hydraulic filters and hydraulic fluid.
• Replace the low-flow hydraulic filter.
• Replace the inner air filter (more often in dirty or dusty conditions).
• Replace the fuel filter.
• Replace the transmission belt.
• Paint chipped surfaces.
• Perform all maintenance procedures listed above before storage.
• Paint chipped surfaces.
• Perform all maintenance procedures listed above before storage.
• Grease the torsion idler.
• Grease the front caster pivots (more often in dirty or dusty conditions).
• Grease the caster-wheel hubs.
• Grease the brake calipers.
• Grease the motion controls.
• Apply anti-seize compound to the cushion knobs.
• Apply dielectric grease to the battery terminals.
27
Advertisement
Table of Contents
