Specifications - Jet 725000 Operating Instructions Manual

5.0 Specifications

Table 1
Model number
Stock number – saw only
(see Table 2 below for kit configurations)
Motor and Electricals
Motor type
Horsepower
Motor phase
Motor voltage
Cycle
Listed FLA (full load amps)
Motor speed
Starting amps
Running amps (no load)
Start capacitor
Run capacitor
Power transfer
On/off switch
Power cord
Plug provided
Recommended circuit size
Sound emission without load
Arbor and blade
Arbor diameter
Arbor speed
Arbor lock
Arbor wrench
Blade included
Maximum depth of cut at 90 degrees
Maximum depth of cut at 45 degrees
Maximum rip to right of blade
Maximum rip to left of blade
Blade height per one revolution of handwheel
Dado maximum width
Dado maximum diameter
Blade tilt
Table
Main table dimensions, L x W
Table dimensions with wings, L x W
Table area in front of blade at maximum height
Table height from floor, approximate
Miter T-slot, W x D
Edge bevel
Main materials
Main table
Table insert
Extension wings
Base and legs
Center trunnion
Pulleys
1
2
JPS2-115
725000
Totally enclosed, fan cooled, induction
1.75 HP
120 V
14.8 A
3450 RPM
36 A
3.7 A
200MFD 125VAC
40F 300VAC
Magnetic switch KJD17B (NVR type)
14AWG x 3, 6 ft (183cm)
5-15P
80 dB at 30 in. (762mm) from blade
5/8 in. (15.88 mm)
4000 RPM
included
included
10 in. (254 mm), 40 tooth
3-1/8 in. (79 mm)
2-1/8 in. (54 mm)
30 in. or 52 in.
13.5 in. (343 mm)
5/32 in. (4 mm) at 90°; 7/64 in. (2.83 mm) at 45°
13/16 in. (20.6 mm)
45° left tilt
20 x 27 in. (508 x 686 mm)
44 x 27 in. (1118 x 686 mm)
8.81 in. (223.83 mm)
34-3/4 in. (883 mm)
3/4 x 3/8 in. (19 x 10 mm)
Cast iron
Aluminum
Cast iron or stamped steel
Aluminum
9
JPS2-230
725001
1 PH
230 V
60Hz
7.4 A
18 A
1.8 A
belt
6-15P
15 A
8 in.
Front
Steel
Steel