Table of Contents
Advertisement
Figure 6-13
6.16 Low profile riving knife
A low profile riving knife is included with your saw.
It mounts and adjusts in the same manner as the
standard riving knife. The low profile riving knife
sits just below top of blade and is used for making
non-through cuts. The blade guard is not used with
this knife, so extra precautions should be taken
during operation.
6.17 Table insert
See Figure 6-14.
1.
Remove blade guard and riving knife.
2.
Lower blade completely.
3.
Place table insert into opening with notched
end towards rear of table, as shown.
4.
Adjust insert flush with table by turning four
leveling setscrews (L) and using a straight
edge at different points over the insert. A
2.5mm hex key is required to adjust the
setscrews.
5.
Turn lock knob (M) so that it catches insert and
holds it against table. If lock knob will not catch
properly, remove insert and adjust spring
tension by turning the nut on the knobs' shaft.
6.18 Miter gauge
See Figure 6-15.
Operate miter gauge by loosening lock knob (A)
and turning miter body (B) to desired angle.
The pin (C) functions as an index stop. When
pushed in, the body will stop at -45º, 90º or +45º
when turned, as one of three screws (D) located
underneath the miter body hits the pin.
You can adjust any play of the miter gauge in the
table slot by tightening set screws (E).
Calibration
If a miter angle at the -45º, 90º or +45º is not
correct, the index stops can be adjusted by turning
one of three adjustment screws (D), then tightening
the hex nut.
Note: Always make test cuts. Do not rely solely on
miter gauge indicator marks.
6.19 Tool storage
The fence assembly can be stored on the motor
cover hooks. Arbor wrench and low profile riving
knife are stored on tool holder on right side of saw.
Below tool holder is a hook for accessory storage.
Install the additional hook (HP1) to any surface of
saw stand with the tapping screws (HP10). Drill
pilot holes before inserting screws.
16
Figure 6-14
Figure 6-15
Advertisement
Table of Contents
