Remove The Solid-State Drive (Ssd) Module - Lenovo IdeaPad 5i Hardware Maintenance Manual

Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove four screws and then remove the battery pack.
Figure 38. Remove four screws and remove the battery pack
Screw specifications
M2 x L5
Go to
https://support.lenovo.com/partslookup
part:
Battery pack

Remove the solid-state drive (SSD) module

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 51
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove the SSD thermalpad.
Figure 39. Remove the SSD thermalpad
Number of screws
4
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
53