I/O board
Remove the fingerprint board with cable
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 34
"Remove the battery pack" on page 35
"Remove the fan" on page 39
"Remove the I/O board" on page 40
Step 1.
Peel off the tape and then disconnect the fingerprint board cable from the system board.
Figure 20. Disconnect the fingerprint board cable
Step 2.
Remove two screws and then remove the fingerprint board with cable.
Figure 21. Remove the fingerprint board with cable
Screw specifications
M1.6 x L2.5
42
Hardware Maintenance Manual
Number of screws
2