Table of Contents
Advertisement
1
Safety Information
1.1
General Guidelines
You must read the following safety information before carrying out any
installation, removal or any maintenance procedure on the Power over
Ethernet Midspan. Warnings contain directions that must be followed for
personal and product safety. Follow all directions carefully.
WARNINGS
•
Read the Installation Instructions in Section 3 before
connecting the Power over Ethernet Midspan to its power
source.
•
The Midspan must use a grounded power cord, as
defined in paragraph 1.2.
•
This product relies on the building installation for short-
circuit (overcurrent) protection. Ensure that a fuse or
circuit breaker no larger than 15 A for 120 VAC, (U.S.) 10
A for 230 VAC (international) is used.
•
Do not work on the system, connect or disconnect cables
during periods of lightning activity.
•
A voltage mismatch can cause equipment damage and
may pose a fire hazard. If the voltage indicated on the
label is different from the power outlet voltage, do not
connect the Power over Ethernet Midspan to this outlet.
•
For shelf-mounted equipment, be certain that the surface
is stable and strong enough to support the equipment. Do
not stack more than four the Power over Ethernet
Midspans.
•
Ultimate disposal of this product should be handled
according to all local laws and regulations.
•
The Power over Ethernet Midspan "Data" and "Data +
Power" ports are shielded RJ-45 data sockets. They
cannot be used as Plain Old Telephone Service (POTS)
telephone sockets. Only RJ-45 data connectors may be
connected to these sockets.
•
Associated ethernet wiring shall be limited to inside of the
building.
PowerDsine
5
The Power over Ethernet Pioneers
P
o
w
e
r
D
s
i
n
e
6
5
0
0
S
P
o
w
e
r
D
s
i
n
e
6
5
0
0
e
r
i
e
s
S
e
r
i
e
s
Hide quick links:
Advertisement
Table of Contents
