Bosch GCM18V-12GDCN Operating/Safety Instructions Manual page 39

1609B06757.qxp_GCM18V-12GDC 3/25/20 12:35 PM Page 39
LONG WORKPIECE SUPPORT
less clamped down and properly sup-
ported from underneath.
table extension or as additional support.
Operating Base Extensions
22
ADDITIONAL WORKPIECE SUPPORT
Blocks
able to properly support the workpiece
and allow for secure holding by hand out-
side of the "No Hand Zone", or clamping
with a clamp inside or outside of the "No
Hand Zone"
support workpiece.
.800.544.2843
Preparing for Saw Operations
Long workpieces have a
tendency to tip over un-
Do not use another per-
son as a substitute for a
21
Always ensure that sup-
porting surfaces are
Always adjust the slid-
ing base extension to
www.calcert.com
15
10 20
5 25
30
0
Be aware of the path of
the saw blade. Make a
dry run with the saw Off by conducting a
simulated cutting cycle, and observe the
projected path of the saw blade. Keep
hands at least six (6) inches (152mm)
away from the projected path of the saw
blade.
Fig. 36
22
Fig. 37
Add Two 2xs
and One 1x
21
39
sales@calcert.com