Clean The Detector; Upgrade The Firmware - Honeywell BW Ultra User Manual

Clean the Detector

Clean the exterior of the detector with a soft, damp cloth. Use only water-based (non-alcohol)
cleaners. Do not use soaps, solvents, or polishes.

Upgrade the Firmware

Upgrade the Firmware via IR Link using Safety Suite Device Configurator (SSDC).
Before you begin:
You should have the IR Connectivity Kit (sold separately) to transfer the data from a
l
computer to the detector.
Note: If connected to the Internet, Safety Suite DC or Safety Suite DM provides the latest
firmware automatically. If not connected to the internet, click on Update and manually add
the latest firmware from Honeywell's official website:
Download Safety Suite Device Configurator (SSDC) from the following website:
l
sps.honeywell.com/us/en/software/safety
For more information refer to the Safety Suite User Guide.
l
Option 1
1. Turn on the detector.
2. Go to the Device Inventory/List and click on the Refresh button to see the connected
devices.
3. Enable the checkbox next to the device serial number and above a blue toolbar will appear.
4. Select the Update firmware button.
5. Follow the status of the process on the Notifications queue.
6. Once the message 'Firmware Updated' appears on the top, click on the Refresh button
again to see the new firmware version on the devices list.
Option 2
1. Turn on the detector.
2. Go to the Device Inventory/List and click on the Refresh button to see the connected
devices.
3. Click over the device serial number.
4. Click the Update button on the Device Details screen below the Firmware Version section.
5. Follow the status of the process on the Notifications queue.
6. The page is refreshed and the new firmware version is listed.
BW Ultra
sps.honeywell.com/us/en/software
and install. (Internet service required)
37 User Manual