Detector Setup - Honeywell Viewguard DUAL AM BUS-2/BUS-1 Mounting And Connection Instructions

8
5.

Detector setup

1 LED yellow
2 LED red
3 Anti-Mask sensor
(only AM detector)
4 Foil for mirror optics
5 Notch
6 Seal
Fig. 2
1 Microwave module
2 Plug connectors for terminal
strip
3 DIP switch S1
for BUS-1 programming
( DIP 5-digit switch with AM
detector )
4 DIP switch S2
for BUS address
5 Mirror optics
6 Tamper / backtamper
(only AM detector)
7 PIR-/BUS module
Fig. 3
6. Mounting
6.1 Mounting site
Maximum sensitivity is achieved when mounted crosswise to the hori-
zontal detection zones of the PIR sensors. Therefore, select a moun-
ting site that runs crosswise to the expected direction of motion. (See
Fig. 6).
Minimum distance to ceiling: 2 cm
Avoid:
* Mounting above radiators
* Mounting near air discharge openings (e.g. air conditioning
systems)
* Direct sunlight
* Mounting near to fluorescent lamps
* Mounting near to light bulbs
Mounting and Connection Instructions Viewguard DUAL / AM BUS-2/BUS-1
6.2 Mounting options
0° Vertical (Fig. 4/1)
Fix with 2 screws (Fig. 5-
Vertical at a 3° downward angle
This position slightly reduces the range. We recommend this
position for small rooms.
Fix with 2 screws: At the bottom by 2 holes at the same height
(Fig.5- ).
Horizontal at a 45° angle to the left or right
Fix through 2 holes above one another at the side (Fig. 5-
Corner mounting (Fig. 4/4)
Fix through 2 holes above one another at the side (Fig. 5- ).
When screwing down the back with 4 screws, it may become
taught and the front of the housing may no longer fit. To avoid this,
only fix the back on one side with 2 screws.
Should these mounting possibilities not suffice, the detector can be
mounted on the "Adjustable joint" (033390) or "Ball-and-socket set"
(033588), see "Accessories.
Attention! Detector on Adjustable joint
Detector on Ball-and-socket set
6.3 Cable entry, strain relief
For s.m. wiring
A
For f.m. wiring
B C
For use with Adjustable joint
C
D For strain relief with cable strap
4/1 4/2
Fig. 4
B
D
C
b
Fig. 5
6.4 Backtamper
(only AM detector)
Required for installation according to EN 50131-2-4, grade 3.
Remove the pin at the tappet
illustration).
(Fig. 4 and Fig. 5)
).
(Fig. 4/2)
(Fig. 4/3)
as per VdS and EN grade 2
not as per VdS und EN
(see Fig. 5)
45°
a)
+/-0°
b)
c)
45°
4/3 4/4
Backtamper is not possible
A
B
Tappet for backtamper
D
a
C
with pin
a
Only tamper
Protective cover for
b
tamper (o n the rear)
Remove, when mounting as
per Fig. 4/3a) or 4/4
Fig. 5a
(see Fig. 5a)
, if the backtamper is being used (see
a
).
.
.
without
pin
Tamper and
backtamper
back-