System Menu - Polycom Vortex EF2201 Reference Manual

S M
YSTEM ENU
System
Power On Preset
Acknowledgeme
nt Mode
Error Messages
Front Panel Lock
Front Panel
Password
Device ID
Baud Rate
Flow Control
Meter
Non-Volatile
Memory Lcok
Non-Volatile Mem
Password
Screen Saver
Last Restored
Preset
Software Version
Reboot
Figure 8. EF2201
System submenu
V EF2201 Reference Manual
ORTEX
adjusted — you should hear changes as the parameter is changing. RS-232 control
strings are also sent via the RS-232 port so your remote control device is instanta-
neously updated as well. Press E
E to cancel the selected value and return to the old value. Pressing H
SC
effect of pressing E then H
SC
menu will return to the top of the menu tree.
Parameters that toggle or select among a list of options will wrap around when you
reach the end, but parameters that adjust numeric values will not wrap around once
the maximum or minimum value is reached. While adjusting a parameter, the U
D button must be held down briefly before the repeat rate increases.
OWN
The S menu contains P
YSTEM
M , F P
ESSAGES RONT ANEL
R , F C , M
ATE LOW ONTROL
M P , S
EMORY ASSWORD CREEN
configurations.
Power On Preset.
Choose the EF2201 Preset for power up.
Acknowledgement Mode.
sages are sent.
Error Messages.
Turns error messages On or Off.
Front Panel Lock.
Locks or unlocks the front panel. When the front panel is
locked, you can see the parameters but you cannot change them.
The default passcode is aspi (case is important).
Front Panel Passcode.
be changed. At the F
RONT
passcode and press E
NTER
Device ID.
Selects the Device ID of the unit.
Baud Rate.
Selects baud rate of the RS-232.
Flow Control.
Selects flow control between Hardware, None, or Auto.
Meter.
Selects which signal is displayed on the front panel LED meter.
Non-Volatile Memory Lock.
the non-volatile memory is locked, you can query the settings but will get an error if
you try to change them.
Non-Volatile Memory Password.
tile lock password. This password is used in conjunction with N
L . The default password is aspi (case is important).
ORY OCK
Screen Saver.
Enables or disables the screen saver on the LCD panel. You can
also set the idle time.
Last Restored Preset.
Software Version.
Queries the software version.
16
to select and store the parameter value or press
NTER
, so the selected value will be cancelled and the
OME
O P , A
OWER N RESET CKNOWLEDGEMENT
L , F P P
OCK RONT ANEL ASSWORD
, N -V M
ETER ON OLATILE EMORY
S , S V
AVER OFTWARE ERSION
This command controls whether or not status mes-
Once the device has been unlocked, the passcode may
P P menu, press E
ANEL ASSCODE
until you reach the end of the screen.
Controls the non-volatile lock feature. When
This feature sets or queries the non-vola-
Displays the last restored Preset.
Technical Support: 800.932.2774
LCD M S
ENU TRUCTURE
has the
OME
/
P
M , E
ODE RROR
, D ID, B
EVICE AUD
L , N -V
OCK ON OLATILE
, and R EF2201
EBOOT
and then enter a
NTER
-V M
ON OLATILE EM
-