Factory Default Settings (Preset 0) - Polycom Vortex EF2201 Reference Manual

Terminating the
EF2201
EF Bus Terminator
needed on EF2201
Figure 5. Terminate the EF Bus link on the EF2280 when connecting an EF2201 to one or more EF2280s.
F D
ACTORY EFAULT
© Polycom, Inc.
and the EF B I
US
Note.
The EF Bus must be connected so that the EF Bus In of one
box is connected to the EF Bus Out of another. Connecting
the EF Bus In to another EF Bus In (or Out to Out) will not
work.
5. Connect another Cat-5 cable between the EF B
the EF B I of the third device, and so on.
US N
6. Power on all units at the same time.
The EF2201 is self-terminating so if you are connecting multiple EF2201s or con-
necting an EF2201 to an EF2241, the EF Bus does NOT need to be terminated. How-
ever, if you are linking the EF2201 to EF2280s, terminate the EF Bus link on the
EF2280.
Cat-5 cable
No terminator is
S (P
ETTINGS RESET
The following is a list of the factory default settings of the EF2201. Since the equip-
ment in your application may have different nominal levels, you can start with a F
P (Presets 0-15), change it to match your environment and then save it
TORY RESET
within the EF2201 as a U
P , set the P
RESET OWER
of the second device.
N
0)
P (Presets 16-47). Once you've saved a U
SER RESET
O P to that U
N RESET SER
9
I
NSTALLATION
O of the second device and
US UT
Vortex EF2280
Vortex EF2201
P (or whichever preset you
RESET
V EF2201 Reference Manual
ORTEX
-
AC
SER