Advertisement
2003 Panasonic AVC Networks Singapore Pte. Ltd. All rights
reserved. Unauthorized copying and distribution is a violation of
law.
1. Before Repair and Adjustment
Disconnect AC power, discharge Power Supply Capacitors C1011 & C1012 through a 10
resistor to ground.
DO NOT SHORT-CIRCUIT DIRECTLY (with a screwdriver blade, for instance), as this may
destroy solid state devices.
After repairs are completed, restore power gradually using a variac, to avoid overcurrent.
Current consumption at AC 220V-240V in NO SIGNAL mode should be ~163 mA .
2. Safety Precautions
2.1. General Guidelines
1. When servicing, observe the original lead dress. If a short circuit
is found, replace all parts which have been overheated or
damaged by the short circuit.
2. After servicing, see to it that all the protective devices such as
insulation barriers, insulation papers shields are properly
installed.
3. After servicing, make the following leakage current checks to
prevent the customer from being exposed to shock hazards.
2.1.1. Leakage Current Cold Check
1. Unplug the AC cord and connect a jumper between the two
prongs on the plug.
2. Measure the resistance value, with an ohmmeter, between the
jumpered AC plug and each exposed metallic cabinet part on the
Dimensions:
Mass:
Power consumption in standby mode: approx. 0.6 W
Note:
1. Specifications are subject to change without notice.
Mass and dimensions are approximate.
430 (W) x 405 (D) x 59.7 (H) mm
4.1kg
3
, 5W
Advertisement
