Advertisement
Error Code
F0BF
6) Unable to replay due to physical
layer identification failure
F0C0
8) DVD: Unable to replay due to no
DVD Video/Audio/VR
F0C1
9) DVD: Prohibited due to illegal
regional code
F0C2
A) DVD: No replay due to PAL system PCND_NOPLAY_PAL
B) DVD: All title replay prohibited in
F0C3
parental setting
F0C4
C) VCD: Prohibited due to PHOTO
CD format
F0C5
D) VCD/CD: Prohibited due to CD-
ROM without CD-DA
9.6. Service Mode Table 2
Pressing various button combinations on the player and remote control unit can activate the
service modes.
Item
Player mode
and button
combination
Jitter check
In STOP
mode, press
"PAUSE" and
"OPEN/
CLOSE"
buttons on
the player,
and "5"
button on the
remote
control unit.
Meaning
Function
Jitter check.
Jitter check is measured
and displayed.
Measurement is repeatedly
done in the cycle of one
second. Read error counter
starts from zero upon
mode setting. When target
block data failed to be read
out, the counter advances
by one increment. When
the failure is cause by
mirror error, it may be
corrected when retried to
enable successful reading.
In this case, the counter
advances by one. When the
erroe persists even after
retry, the counter may jump
by two or more.
16
System Computer Item
PCND_NOPLAY_PHYSICAL
0x50
PCND_NOPLAY_VIDEO
0x70
PCND_NOPLAY_RCD
0x80
0x90
PCND_NOPLAY_PTL
0xA0
PCND_NOPLAY_PHOTOCD
0xB0
PCND_NOPLAY_CDROM
0xC0
Jitter rate is shown in decimal
notation to one place of decimal.
Focus drive value is shown in
hexadecimal notation.
You may have to press "FL-
SELECT" on remote control to
veiw remaining text due to FL
display not able to display full
length.
Setting Task
DriveManager 0xD0BF
DiscManager 0xD0C0
DiscManager 0xD0C1
DiscManager 0xD0C2
DiscManager 0xD0C3
DiscManager 0xD0C4
DiscManager 0xD0C5
Display
Internal
error
system
computer
Cancellation
method
Press
or OPEN
CLOSE
button.
Advertisement
