Steps
1. Slide the hard drive into the hard-drive carrier.
2. Replace the two screws (6-32) to secure the hard drive to the hard-drive carrier.
3. Align the tabs on the hard-drive carrier with the slots on the chassis and snap the hard-drive carrier onto the disk-drive
cage.
4. Replace the two screws (6-32) to secure the hard drive carrier on the chassis.
5. Connect the data and power cables to the connectors on the hard drive.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Hårddiskbur
Ta bort hårddiskburen
Förutsättningar
1. Följ anvisningarna i
Innan du arbetar inuti
2. Ta bort sidopanelen.
3. Ta bort frontramen.
4. Ta bort
2,5-tums hårddisken
5. Ta bort
3,5-tums hårddisken
After working inside your
datorn.
i tillämpliga fall.
i tillämpliga fall.
Ta bort och installera enheter som kan bytas av kund (CRU:er)
computer.
47
Need help?
Do you have a question about the OptiPlex Small Form Factor 7010 and is the answer not in the manual?
Questions and answers