Dell OptiPlex Small Form Factor 7010 Owner's Manual page 59

The following image indicates the location of the M.2280 solid-state drive and provides a visual representation of the installation
procedure.
Steps
1. Peel off the protection film on the thermal pad and align and adhere the thermal pad on the M.2 2230 solid-state drive slot
on the system board.
NOTE: The thermal pad is re-usable. The thermal pad is pre-installed on systems shipped with solid-state drive. If the
solid-state drive is purchased separately, the thermal pad is not bundled with the solid-state drive kit and is to be
purchased separately.
Ta bort och installera enheter som kan bytas av kund (CRU:er) 59