Quick Start; Preparation For Start-Up; Hardware Connections - Ebyte E890-470LG12 User Manual

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

1. Quick Start

To ensure that the product the user gets in the first place is qualified, here we provide a simple testing process for

the user to refer to throughout the process, while also allowing the customer to act as a quick start.

Before working on the LORAWAN gateway, the user needs to prepare at least one PC, one network cable and

product supporting devices.

Connect the WIFI antenna, and LoRa antenna, respectively, to the SMA connector under the device panel logo, as

shown above, before powering up the device (the power-up location is identified at the panel). After the above steps have

been completed, use the power supply that came with the device and then power up the gateway. Connect the computer

to the WIFI of the device (WIFI name E890-XXXX) and the WAN port of the device to Ethernet.

After power on, wait for about 1 minute or so, the WORK indicator on the panel is always on, which indicates that

the power on is complete, in addition, on the panel, the LoRa signal indicator and the indicator in the network properties

also start to work properly.

To ensure that the computer can access the WEB management interface via the LAN, the customer needs to ensure

that the computer's network properties are to automatically obtain an IP address, as well as to automatically obtain a DNS

server address, as shown in the figure below.

1-3

E890-470LG12 User Manual

Table of Contents