Table of Contents
Advertisement
Name
NO.
Def.
A B C
Valid
Basic Set
2
0xFF
All
Level
3
PIR
0 ~
80
(*)
Sensitivity
99
Light
0 ~
4
99
Threshold
100
Description
Setting the BASIC command value to
turn on the light. The 0xFF(-1) means
turn on the light. For dimmer
equipment 1 to 100 means the light
strength.
0 means turn off the light.
Caution: The value is unsigned byte,
the range is from 0x00 ~ 0xFF.
PIR sensitivity settings.
0 means disable the PIR motion.
1 means the lowest sensitivity,
99 means the highest sensitivity.
High sensitivity means can detected
long distance, but if there is more
noise signal in the environment, it will
re-trigger too frequency.
Setting the illumination threshold to
turn on the light. When the event
triggered and the environment
illumination lower then the threshold,
the device will turn on the light.
0 means turn off illumination detected
function. And never turn on the light.
1 means darkest.
99 means brightest.
100 means turn off illumination
detected function. And always turn on
the light.
Notice: In none test mode, only the
value in 1 to 99 will enable the
illumination detected function and
update the illumination value.
Name
NO.
Def.
Valid
0
All
0
0
0
5
Operation
(*)
Mode
0
0
0
0
0
9
Description
A B C
Operation mode. Using bit to control.
Caution: The value is unsigned byte,
the range is from 0x00 ~ 0xFF.
Bit0: Reserve.
Bit1: 1 means test mode,
0 means normal mode.
Notice:
This bit only effect by the DIP Switch
setting to "customer mode", otherwise
it decides by DIP Switch setting to Test
or Normal Mode.
Bit2: Disable the door/window
function. (1:Disable, 0:Enable)
Bit3: Setting the temperature scale.
0: Fahrenheit , 1: Celsius
Bit4: Disable the illumination report
after event triggered. (1:Disable,
0:Enable)
Bit5: Disable the temperature report
after event triggered. (1:Disable,
0:Enable)
Bit6: Reserve.
Disable the back key release
Bit7:
into test mode. (1:Disable,
0:Enable)
Advertisement
Table of Contents
