Testing - Hayward HP40B Installation & User Manual

VII. TESTING
1. Inspection before use
a. Check installation of the whole machine and the pipe connections according to the pipe
connection diagram
b. Check the electric wiring according to the electric wiring diagram; and make sure the Heat Pump is
bonded
c. Make sure that the main machine power switch is off
d. Check the temperature setting.
e. Check the air inlet and outlet.
2. Trial
a. The user must "Start the Pump before the Machine, And Turn off the Machine before the
Pump", or the machine will be damaged
b. The user should start the pump, check for any water leakage of water; set temperature in the
thermostat, and then switch on power supply.
c. In order to protect the swimming pool heater, the machine is equipped with a time delay
starting function, when starting the machine, the blower will run for 3 minutes before the
compressor starts.
d. If at any time there is an abnormal noise, smell, smoke, electricity leakage, please switch
off power immediately and contact your local dealer. All repairs must be performed by a
qualified technician.
13