1.5. Pci Card Slot Requirements; 1.6. Low-Profile Bracket; 1.7. Multicam Driver Installation Procedure - Euresys 1624 Grablink Base Installation Manual

1.5. PCI Card Slot Requirements

For optimal performance:
● 1623 Grablink DualBase, 1622 Grablink Full and 1626 Grablink Full XR must be plugged into a x4, x8 or x16 PCI Express
Gen 1 (or higher) card connector providing at least four active lanes.
1624 Grablink Base and 1621 Grablink Express must be plugged into a x1, x4, x8 or x16 PCI Express Gen 1 (or higher)
●
card connector.
1191 Grablink Value must be plugged into a 64-bit 66 MHz conventional PCI slot providing +3.3 V, +5 V, +12 V and -12 V
●
power supplies.
To guarantee proper operation and longer board reliability, ensure an adequate cooling of the card. The cooling is improved
by a higher air flow circulating around the board. This air flow is increased, for example, by using computer case fans. In
addition, avoid placing a Coaxlink card next to other heat dissipating boards.

1.6. Low-Profile Bracket

1624 Grablink Base is delivered with two brackets: a full-height bracket and a low-profile bracket.
To install such a board in a low-profile computer, replace the existing full-height standard bracket with the low-profile
bracket included in your kit: If needed, first unplug the flat cable from the internal connector. Remove the original standard-
profile bracket by unscrewing the screw locks; keep the screw locks. Install the low-profile bracket; secure it on the board
with the screw locks.

1.7. MultiCam Driver Installation Procedure

The MultiCam driver is distributed on the support section of the Euresys website:
https://www.euresys.com/Support/Software,-drivers-and-documentation
.
Note: The Euresys website download area may require user authentication. The user ID and password are not obtained,
they are chosen by the user. Access is free and unrestricted.
1. Select the Grablink product series to display the file list corresponding to the latest available MultiCam release.
2. Select the setup file corresponding to your operating system and your processor architecture
□ The <OS> field designates the operating system:
□ The <ARCH> optional field designates the processor architecture:
□ The <MA.MI.RE.BU> designates respectively the major and minor version numbers, the revision and the build
numbers of the driver package
□ <The EXT> field designates the file type:
Important: For an installation on Windows 10, use the
with drivers signed by Microsoft!
3. Run the MultiCam installer:
a. On Windows, launch the installer tool to install the driver files and software tools on your PC.
Note: If you have an existing MultiCam driver already installed, the installer tool prompts you to uninstall it before being
able to continue. Otherwise, it prompts you for the selection of the destination folder.
b. On Linux, extract the files from the tar.gz archive, change directory to the extracted
the
install.sh
multicam-<OS>-[<ARCH>-]<MA.MI.RE.BU>.<EXT>
exe
script as .
root
, ,
linux win win10
,
x86
,
tar.gz
multicam-win10-[<ARCH>-]<MA.MI.RE.BU>.exe
x86_64
folder and execute
multicam
setup file