Table of Contents
Advertisement
Installing the moniceiver
7.2
Installing and connecting the moniceiver
A
NOTICE! Beware of damage!
• When drilling holes, check beforehand that there is sufficient space
on the other side for the drill head to come out.
• Cables and connections that are not properly installed will cause
malfunctions or damage to components. Correct installation of
cables and connections ensures lasting and trouble-free operation of
the retrofitted components.
Observe the following installation instructions:
• When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 6, page 5).
• Attach the cables securely in the vehicles to prevent tripping hazards. Use e.g.
cable binder, insulating tape or adhesive for this.
• Check beforehand that there is sufficient space on the other side for the drill head
to come out (fig. 5, page 5).
• The device must not be fitted at an angle of more than 30° to the horizontal.
Otherwise, it cannot be guaranteed that the
CD / DVD player will function correctly.
For the complete wiring diagram see fig. b, page 8:
Label
TV
RADIO ANT
A + B
SWC
FRONT R
FRONT L
REAR R
REAR L
SUB OUT
VIDEO OUT
TV BUS
24
Description
TV antenna input
Radio antenna input
ISO plug
Connection for steering wheel control
Audio output (R) for front
Audio output (L) for front
Audio output (R) for rear
Audio output (L) for rear
Connection for subwoofer
Video
No function assigned
MC402
EN
Advertisement
Table of Contents
