Table of Contents
Advertisement
MC402
7
Installing the moniceiver
A
NOTICE! Beware of damage!
Before installing the monoceiver, remove the two screws used to
protect it during transport so that the DVD player can function.
7.1
Notes on the electrical connections
Please observe the following instructions relating to the electrical connection:
• This device is intended for use only in vehicles with 12 Vg and negative earth.
Ensure that the vehicle has the required 12 V voltage before installing the device.
If no voltage of 12 Vg is available, then a voltage converter must be used.
• If the ignition socket of your vehicle does not have an ACC position (starter
battery), install a switch between the ACC cable and the power supply.
• If you have put in a new fuse, but faults still occur, then approach the
manufacturers (see addresses on back), the manufacturers' customer service
department or a similarly qualified individual.
• Ensure that all electrical connections and the loudspeaker cables are well
insulated in order to avoid short circuits.
• Ensure that the screws for protecting the device during transport (fig. 9 1
page 6) are removed from the upper side of the device prior to installation.
EN
Installing the moniceiver
23
Advertisement
Table of Contents
