Releasing The Edge; Installing The Mountain Bike Mount; Acquiring Satellite Signals; Training - Garmin EDGE 1030 PLUS Owner's Manual

7
Press down slightly and turn the Edge device clockwise until
it locks into place.

Releasing the Edge

1
Turn the Edge clockwise to unlock the device.
2
Lift the Edge off the mount.

Installing the Mountain Bike Mount

NOTE: If you do not have this mount, you can skip this task.
1
Select a secure location to mount the Edge device where it
does not interfere with the safe operation of your bike.
2
Use the 3 mm hex key to remove the screw
handlebar connector .
3
Select an option:
• If the handlebar diameter is 25.4 mm, place the thicker
pad around the handlebar.
• If the handlebar diameter is 31.8 mm, place the thinner
pad around the handlebar.
• If the handlebar diameter is 35 mm, do not use a rubber
pad.
4 Place the handlebar connector around the handlebar, so that
the mount arm is above the bike stem.
5
Use the 3 mm hex key to loosen the screw
arm, position the mount arm, and tighten the screw.
NOTE: Garmin recommends tightening the screw so the
mount arm is secure, with a maximum torque specification of
20 lbf-in. (2.26 N-m). You should check the tightness of the
screw periodically.

Training

6
If necessary, use the 2 mm hex key to remove the two
screws on the back side of the mount
the connector, and replace the screws to change the
orientation of the mount.
7
Replace and tighten the screw on the handlebar connector.
NOTE: Garmin recommends tightening the screw so the
mount is secure, with a maximum torque specification of
7 lbf-in. (0.8 N-m). You should check the tightness of the
screw periodically.
8
Align the tabs on the back of the Edge device with the bike
mount notches
from the
9
Press down slightly and turn the Edge device clockwise until
it locks into place.

Acquiring Satellite Signals

The device may need a clear view of the sky to acquire satellite
signals. The time and date are set automatically based on the
GPS position.
TIP: For more information about GPS, go to
/aboutGPS.
1
Go outdoors to an open area.
The front of the device should be oriented toward the sky.
2
Wait while the device locates satellites.
It may take 30–60 seconds to locate satellite signals.
on the mount

Going for a Ride

If you are using a wireless sensor or accessory, it can be paired
and activated during initial setup
Sensors, page
wireless sensor, they are already paired and can be activated
during initial setup.
1 Hold
2
Go outside, and wait while the device locates satellites.
The satellite bars turn green when the device is ready.
3
From the home screen, select
profile.
4
Select
5
Select
.
Training
(Pairing Your Wireless
17). If your device was packaged with a
to turn on the device.
or
.
to start the activity timer.
, remove and rotate
www.garmin.com
to select an activity
3