Sharp PN-70TW3 Operation Manual page 34

Menu Items
AUDIO OPTION
SPEAKER SELECT
Set whether to use the built-in speakers or the external speakers connected to the external speaker terminals.
AUDIO OUTPUT
Sets the volume of sound output from the audio output terminals.
VARIABLE1 ........ You can adjust the volume from the speakers of this monitor and the audio output terminal simultaneously
by using VOLUME.
VARIABLE2 ........ You can adjust the volume from the audio output terminal by using VOLUME.
Sound will not be output from the speakers of this monitor.
FIXED................. Fixes the volume from the audio output terminal. Adjust the volume by using an external device.
You can adjust the volume from the speakers of this monitor by using VOLUME.
* The output sound from the speakers of this monitor (internal/external) varies depending on SPEAKER SELECT.
AUDIO INPUT LEVEL 1/2
Selects the maximum audio input level of the audio input 1, 2 terminals.
TOUCH INPUT SELECT
These settings enable use of the touch panel according to input mode selection.
BOTTOM USB
Sets which input mode the touch panel connected to the USB 1 port is used in. Select the terminal into which the video
signal of the computer connected to the USB 1 port will be input.
When BOTTOM INPUT TERM. is selected and the input mode is DisplayPort, HDMI1, or D-SUB1, the touch panel can be
used with the computer connected to the USB 1 port.
When "-" is selected, the touch panel cannot be used.
SIDE USB
Sets which input mode the touch panel connected to the USB 2 port is used in. Select the terminal into which the video
signal of the computer connected to the USB 2 port will be input.
When SIDE INPUT TERM. is selected and the input mode is HDMI2, HDMI3, or D-SUB2, the touch panel can be used with
the computer connected to the USB 2 port.
When "-" is selected, the touch panel cannot be used.
START INPUT MODE
You can set the input mode that will be in effect when the power is turned on.
When this is set to LAST INPUT MODE, the input mode when the power was last turned off will appear.
* When NO SIGNAL AUTO INPUT SEL is ON and there is no input signal in the set input mode, the input mode will change to
the input mode that has an input signal.
COMMUNICATION SETTING
RS-232C/LAN SELECT
Selects the method with which to control the monitor from the computer.
BAUD RATE
Selects the communication speed used for RS-232C communication.
LAN SETUP
Configures the settings to control the monitor from the computer via LAN. (See page 53.)
WIRELESS SETTING
WIRELESS FUNCTION .................... Set whether or not the wireless controller's wireless LAN is used.
CONNECT AUTO INPUT SELECT ... Set whether or not the input automatically changes to Wireless when a video signal is
REGION SETTING (WIRELESS) ..... Select the region to use this monitor.
34
E
Even when this is set to OFF, the LAN terminal of the wireless controller can be used.
* When the setting is changed, the monitor restarts.
input via the wireless controller.
After setting, select SET and press
* When the setting is changed, the monitor may restarts.
* The channels and frequencies that can be used for wireless LAN vary by country and
region.
Be sure to set the region to use.
ENTER
.