Husqvarna DE 110 SH Operator's Manual page 9

the product to make sure that it is fully
attached. Do not use an extension cable that
makes a loose connection.
Note:
The operation conditions are 800 m/2625 ft
maximum altitude, temperature between -10⁰C/14⁰F to
+40⁰C/104⁰F and humidity 85%.
Note:
Read the operator's manual of the attached
equipment carefully. If specified requirements or settings
are given for the dust extractor, make sure that you obey
these.
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
schedule on page 15 .
3. Make sure that the work area is clean and bright.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
5. Make sure that the product is installed correctly.
6. Make sure that the frequency and voltage shown on
the type plate agrees with the power supply voltage.
This is also applicable for the extension cables.
7. Attach the product cord (A) with the extension cable
(B) during operation to make sure that they stay
connected.
B
To attach the dust extraction hose
WARNING:
prevent antistatic effects.
1. Open the hose connector.
1587 - 011 - 06.03.2023
Maintenance
A
Use an antistatic hose to
2. Put the hose adapter in the hose connector.
3. Push the hose adapter until you hear a click to get it
in correct position.
To remove the dust extraction hose
• Push the hose lock button (A) and pull the dust
extraction hose.
To attach and adjust the floor nozzle
1. Put the end of the handle fully into the shaft of the
floor nozzle.
A
9