Husqvarna DE 110 SH Operator's Manual page 12

4. Push the On/Off switch.
a) Push "I" to start the product.
b) Push "II" for automatic start. Refer to
start function (Only 230V DE 110 SH and DE 110
H) on page 11 .
5. To stop the product, set the On/Off switch to "0".
6. Disconnect the product from the power socket.
To start and stop DE 110 H/DE 120 H
Note:
Wait for 5 seconds after you start the product
to operate with full suction. The suction is not at full
capacity directly at start.
1. Make sure that the frequency and voltage shown on
the rating plate agree with the power supply.
2. Connect the product to an applicable power socket.
3. Push the "I" on the main switch to start the product.
12
4. Push the On/Off button to start and stop the
operation.
a) Push "I" to start the operation.
Automatic
b) Push "A" for automatic operation start. Refer to
5. To stop the operation, push the On/Off button. The
button goes off when you stop the operation.
6. Push the "0" on the main switch to stop the product.
7. Disconnect the product from the power socket.
Hour meter (DE 110 H/DE 120 H)
The hour meter shows the total operation time of the
product in hours.
To remove dust particles from the
prefilter during operation
The filter purge procedure cleans the prefilter from
unwanted material. Do the procedure in these situations:
• Stop the product to let the dust fall into the Longopac
bag.
• Before a work stop or at the end of each work day.
If the product is off for a while, it gives the dust
more time to fall down. This makes the filter purge
procedure more powerful.
• When the suction is not sufficient.
• Before installation of a new Longopac bag.
• When the prefilter clogged alarm goes off.
1. Start the product. Refer to
SH on page 11 or To start and stop DE 110 H/DE
120 H on page 12 .
Automatic start function (Only 230V DE 110 SH
and DE 110 H) on page 11 .
To start and stop DE 110
1587 - 011 - 06.03.2023