Operation - Milwaukee M18 FUEL 2874-22HD Operator's Manual

ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Installing/Removing Die Heads
Die head can be inserted from either side of the tool.
1. Remove battery pack.
2. Rotate the die head lock ring to
the unlocked position.
3. Insert the die head and rotate
back and forth slightly to
engage torque keys.
4. Rotate the die head lock ring
to lock. The lock ring will click
when locked.
5. Always check the die head is locked into the tool
before starting a cut.
6. To remove, unlock the die head lock ring and pull
the die head from the tool.
ONE-KEY™
To learn more about the ONE-KEY™ function-
ality for this tool, please reference the Quick
Start guide included with this product or go to
milwaukeetool.com/One-Key. To download the
ONE-KEY™ app, visit the App Store or Google Play
from your smart device.
ONE-KEY™ Indicator
Solid Blue Wireless mode is active and ready
to be configured via the ONE-KEY™
app.
Blinking Blue Tool is actively communicating with
the ONE-KEY™ app.
Blinking Red Tool is in security lockout and can
be unlocked by the owner via the
ONE-KEY™ app.

OPERATION

To reduce the risk of injury, always
WARNING
wear proper eye protection marked
to comply with ANSI Z87.1.
Resisting Threading Forces
Always use the support device provided with the
tool. The support arm clamps to the pipe and helps
to resist the threading forces. WARNING! Loss of
control during operation can result in personal injury.
1. Position the support arm jaws
around the pipe. To properly
place the support arm for
threading, the support arm
should be parallel to the pipe
and the end of the support
arm should match up with
the end of the pipe.
2. Turn the tightening arm to
clamp down securely on the
pipe.
3. Place the tool with installed
die head over the pipe.
4. Slide the support arm through
the tool's support arm brac-
ing point. WARNING! Do not
attach the tool to the support
arm in any other location.
5. Continue to slide the tool over
the pipe until the end of the
pipe contacts the cutting dies
in the die head. The support
arm will be inside the tool's
bracing point.
Selecting Speed
The speed selector is on top of
the housing. Allow the tool to
come to a complete stop before
changing speeds.
1. For pipe diameter 1-1/4" or
larger, turn the dial to "1".
2. For pipe diameter less than
1-1/4" diameter, turn the dial
to "2".
4
Support
Arm