Spare Parts; Tools For Maintenance - Maxwell 2500 HWC Manual

spring (8) on top of it, turning its bigger diameter
towards the chainwheel (picture 5.2).
 Install the outer clutch cone (7), after applying
marine grease to its conical surface (picture 5.2).
 Assemble drum (6) on top of the clutch cone.
 Assemble clutch nut (5).
 Put retaining washer (4) on top of the main shaft
and secure it with the countersunk screw (3).
 Insert plastic cap (1) into the clutch nut.
5.4

SPARE PARTS

VETUS-Maxwell recommends a modest quantity of
spare parts to be ordered as familiarity with the
windlass is developed during installation. Frequently
smaller parts are lost during maintenance, so
keeping spares (and spare tools) is recommended.
We recommend the following list of spare parts to be
carried on board:
Part no. Description
SP2790 O-ring (cap seal)
5953 Disc Spring
2311 Retention Clip
3207 Key - Topworks
3150 Key - Gearbox
7068 Washer
2310 Spring
SP2764 Circlip
O-Ring – Elect Motor
SP2787
If you need any other spare part, please refer to the
Appendix B for the correct part number and contact
one of our distributors worldwide (Appendix E).
When ordering spare parts, please also quote the
serial number of the windlass.
5.5 TOOLS FOR MAITENANCE
We recommend the following tools be kept on board
for disassembling and assembling the windlass:

Set of metric hexagon keys

Ring / open end spanner 13, 15, 17 and 19mm

Flat screw driver 10mm blade width

Circlip pliers
VETUS-Maxwell APAC Ltd
Qty
1
2
2
2
1
1
1
2
1
2500 HWC 17