Handlebar Switches - Yamaha NMAX 2016 Owner's Manual

V-belt replacement tripmeter mode
1
1. V-belt replacement indicator "V-BELT"
2. V-belt replacement tripmeter
The V-belt replacement
shows the distance traveled since it
was last reset (i.e., since the last V-belt
replacement).
The V-belt replacement indicator "V-
BELT" will flash at every 18000 km
(10500 mi) thereafter to indicate that
the V-belt should be replaced.
After replacing the V-belt, reset the V-
belt replacement tripmeter and the V-
belt replacement indicator. To reset
them both, select the V-belt replace-
ment tripmeter, and then push the
"RESET" button for one second. Then,
while "V-BELT" and the V-belt replace-
ment tripmeter are flashing, push the
"RESET" button for three seconds. The
V-belt replacement indicator will be re-
set.
If the V-belt is replaced before the V-
belt replacement indicator comes on
(i.e., before the periodic V-belt replace-
ment interval has been reached), the V-
belt replacement tripmeter must be re-
set for the next periodic V-belt replace-
ment to be indicated at the correct
time.
Instrument and control functions
2
tripmeter

Handlebar switches

Left
1
2
3
1. Dimmer switch "
2. Turn signal switch "
3. Horn switch "
Right
1. Start switch "
Dimmer switch "
Set this switch to "
beam and to "
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
3-9
EAU1234M
/ "
/ "
"
1
"
EAU12401
/ "
" for the high
" for the low beam.
EAU12461
/ "
". When
3