Figure D-2. Multi-Function Adapter Class In The Device Manager - National Instruments PCMCIA Serias Getting Started

Appendix D Troubleshooting and Common Questions
PCMCIA Serial for Windows 98/95
address, refer to the Selecting Conflict-Free Resources
this appendix.
How do I change the resources assigned to PCMCIA two-port or
four-port serial cards?
Because the two-port PCMCIA cards are single physical devices that
support multiple ports, they are registered as "multi-function adapters" in
the Device Manager. Each port is a child device listed under Ports (COM
& LPT). Windows 98/95 does not allow the resources of the multi-function
child devices to be changed directly.
To change the resources of ports on two-port PCMCIA cards from within
the Device Manager, you must open the Multi-function adapters class and
double-click on the Multi-function Parent item that corresponds to your
National Instruments serial interface. Use the Resources page to change
the resources. Any resource changes are automatically reflected to the child
devices. Figure D-2 shows the Multi-function adapters class in the
Device Manager.

Figure D-2. Multi-Function Adapter Class in the Device Manager

D-6
section earlier in
© National Instruments Corporation