Panasonic AW-HN130WPC Operating Instructions Manual page 80

Web screen configurations (continued)
Gamma
Adjust the gamma correction level.
Specifying smaller values results in a gentler gamma curve for the
slope of low-brightness areas and sharper contrast.
Specifying larger values results in an expanded gradient for dark
areas and produces brighter images. The gamma curve for low-
brightness areas will be steeper, and contrast will be softer.
Setting range: 0.30 to 0.75
Factory settings: 0.45
DRS
Set the DRS function which performs correction when video with high
light/dark contrast is displayed.
You can select from a [Low], [Mid], or [High] effect level.
Depending on the scene, noise may worsen.
Setting value: Off / Low / Mid / High
Factory settings: Off
<NOTE>
• When DRS is enabled, knee settings ([Knee Mode], [Knee Point],
[Knee Slope]) and [Gamma Type] and [Gamma] settings are
disabled.
Knee Mode
Set the operating mode for gradation compression (knee).
Setting value:
Off Turn the knee function off.
Auto Enable the knee function, and set the knee point and knee
slope automatically.
Manual Enable the knee function, and set the knee point and knee
slope manually.
Factory settings: Auto
Knee Point
Set the compression level (knee point) position for high-brightness
video signals.
This is only enabled when [Knee Mode] is set to [Manual].
Setting range: 70.0% to 107.0%
Factory settings: 93.0%
Knee Slope
Set the knee slope.
This is only enabled when [Knee Mode] is set to [Manual].
Setting range: 0 to 99
Factory settings: 85
<NOTE>
• When [DRS] is enabled, the knee setting is disabled.
White Clip
Turn the white clip function off/on.
Setting value: Off /On
Factory settings: On
White Clip Level
Set the white clip level.
This is only enabled when [White Clip] is set to [On].
Setting range: 90% to 109%
Factory settings: 109%
<NOTE>
• When [Knee Mode] is set to [Auto] and the white clip value is
changed, the knee value will also change.
DNR
Set the digital noise reduction level for outputting bright, clear images
without noise, even at night and low-light conditions.
Selecting [Low] or [High] removes noise.
However, image lag may increase.
Setting value: Off / Low / High
Factory settings: Off
z Matrix settings screen [Matrix Settings]
„
Set matrix settings.
To display the Matrix Settings screen, click the [Setup] button for [Matrix
Type] at the bottom of the Image/Position screen.
These settings can only be configured when [Matrix Type] is set to
[User].
The settings in this screen are applied immediately.
80