Table of Contents
Advertisement
C.
Repeat steps 8A and 8B for each weight plate.
D.
Carefully slide top weight (removed in step 7J) over guide rods.
9. Cable routing.
A.
Verify cable is routed through top of pulley bracket and then route cable end to top weight
connector.
B.
Pull cable tight and secure in place with roll pin removed in step 7H.
C.
Place weight stack pin in each plate to verify proper installation.
D.
Without selecting any resistance, lift top weight up and down (simulating normal operation).
E.
Have an assistant verify that the cable is moving smoothly and is routed straight from the pulley bracket to
the top of the weight plate connector.
10. Install back shroud.
A.
Carefully place shroud into position.
B.
Secure top cap in place with the two BHSCS removed in step 7A.
11. Complete Steps 4 and 5.
Assembly
Page 4-4
Cybex VR1 13050 Leg Extension Owner's Manual
Advertisement
Table of Contents
