Table of Contents
Advertisement
Warning for the first wash
EN
After installation, remove the buffers placed on the baskets
and the retaining bands on the upper basket (where
provided)
Water softener settings
Before starting the first wash, set the hardness level of the
mains water. (see chapter Rinse aid and regenerating salt)
The first loading of the softener reservoir must take place with
water, then introduce about 1 kg of salt; it is normal for water
to escape.
Start a wash cycle immediately afterwards.
Use only dishwasher-specific salt. After charging, the LACK
OF SALT * indicator goes out.
Failure to fill the salt container may cause damage to the
water softener and the heating element.
Technical data
Dimensions
Capacity
Water supply
pressure
Power supply
voltage
Total absorbed
power
Fuse
6
width 60 cm
height 85 cm
depth 60 cm
14 standard place-settings
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
7,25 – 145 psi
See appliance data plate
See appliance data plate
See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage)
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/EU Waste Electrical
and Electronic Equipment (WEEE)
The machine is equipped with acoustic / tone signals
(according to the model of dishwasher) that warn of the
command: ignition, end of cycle etc.
The symbols / lights / LEDs on the control panel / display
may vary in color, pulsate or be in constant light (according
to the model of dishwasher).
The display displays useful information related to the type of
cycle set, to the washing / drying phase, to the remaining time,
to the temperature, etc.
*
Only available in selected models.
Advertisement
Table of Contents
