Mio Kiron Series User Manual page 40

Table of Contents

Advertisement

Never attempt to disassemble, repair or make any modifications to your device. Disassembly,
modification or any attempt at repair could cause damage to your device and even bodily injury or
property damage and will void any warranty.
Keep your device and its accessories out of the reach of small children or animals.
Do not store or carry flammable liquids, gases or explosive materials in the same compartment
as your device, its parts or accessories.
To discourage theft, do not leave the device and accessories in plain view in an unattended
vehicle.
Do not leave the device and its accessories in a vehicle in direct sunlight. Overheating may
damage the device.
The device (excluding accessories) is protected again splashes, water and dust. When tested
under controlled laboratory conditions, the device is compliant with the IP67 rating of the IEC
60529 standard. The manufacturer guarantees this grade provided all jack covers are properly
and securely closed. Immersion in water or water-pressure such as washing the unit with running
water may cause damage to the unit and voids warranty. Normal wear might decrease resistance.
The device should not be operated in water.
Regulatory Information
For regulatory identification purposes, F700/Kiron series is assigned a model number of N564/N564 B.
Marking labels located on the exterior of your device indicate the regulations that your model complies
with. Please check the marking labels on your device and refer to the corresponding statements in this
chapter. Some notices apply to specific models only.
Maximum radio frequency (RF) power for Europe:
WLAN 2.4 GHz: 20 dBm
WLAN 5 GHz: 20 dBm
Bluetooth: 10 dBm
FCC
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
40

Advertisement

Table of Contents
loading

Related Products for Mio Kiron Series

This manual is also suitable for:

Miowork f700 f700

Table of Contents