Installation - ebm-papst ECI-42 K1 Series Translation Of Original Operating Instructions

Installation

5 Installation
Dangerous movements
Check the electrical equipment of the drive at regular intervals.
→ Ensure there are sufficient protective fixtures in the devices/systems, as actuating the drives in the wrong
way can lead to dangerous movements.
Possible remedial actions include:
→ No lingering within the movement area of the devices or systems.
DANGER
→ Ensuring that the stability of the (protection) covers and housing is sufficient enough to resist the maximum
movement or rotation energy.
→ Before opening the drives or entering the danger zone, ensure all connected drives are safely brought to a
standstill, are de-energized, and are secured against switching on again.
Impermissibly high load
Do not make any changes to the drive
→ Subjecting the drive to impermissible loads (e.g. impact, heat, overvoltage, mechanical load) might damage
WARNING
it. In this case, decommission the product immediately and, before recommissioning it, check that it is in
proper condition.
Electromagnetic radiation
When integrating the drive into the system, the interaction may cause interference in terms of electromagnetic
WARNING
compatibility (EMC). Ensure that the entire system is electromagnetically compatible.
Health hazards for persons with pacemakers, metal implants, and hearing aids
For these people, access to the following areas is prohibited:
→ Areas in which electrical devices and parts are assembled, operated, or put into operation.
WARNING
→ Areas in which motor parts with permanent magnets are stored, repaired, or assembled.
Depending on the installation and operating conditions, the sound pressure level may exceed 70 dB(A)
Risk of noise-induced hearing loss
→ Take appropriate technical safety measures.
WARNING
→ Protect operating personnel with appropriate safety equipment such as hearing protection.
Hot surface – risk of burns
→ Ensure sufficient protection against accidental contact.
CAUTION
→ Ensure there is sufficient cooling.
Risk of cutting and crushing hazard when removing drive from packaging and when assembling
Carefully remove the drive from packaging, touching only the housing. Never subject to any impacts!
→ Wear safety shoes and cut-resistant safety gloves.
CAUTION
20/28
Item no.: 601.2055 · ENU · Change V1.1 · Release 2022-10-11
Drive concepts Drive concepts
SIMATIC MICRO-DRIVE SIMATIC MICRO-DRIVE