Table of Contents
Advertisement
On the second screen of the settings section (Fig. . page ), the rst item Date / time can be used to set the date
and time of the device. This is important for the correct operation of time programs.
Webserver – name sets the login name for accessing the heat pump via a web browser by entering the IP address in
the address bar of the browser (the device from which the heat pump is accessed must be connected to the same Ethernet
network as the heat pump).
Webserver – pass. sets the login password for accessing the heat pump via a web browser.
Saved data allows you to view the complete history of recorded information about the heat pump operation (data is
only available when accessed via a web browser).
Network settings allows you to set network addresses, reports and remote access (Fig. . page , Fig. . page
and Fig. . page ).
Language setting allows you to set the default language of the device (Fig. . page ).
Silent mode allows you to activate/deactivate the silent mode.
Only during attenuation enables the silent mode only during the attenuation time.
At the bottom of the screen, Service access can be used to log into the service settings section. The last page of the
Settings section contains Logout , which can be used to log out of the service section.
The rst four items of the Network settings screen (Fig. . page ) can be used to set a static IP address, mask,
gateway and DNS for connection to an Ethernet network. If these settings are changed, they must be saved using
Use new network settings .
If a DHCP server is active in the Ethernet network, you can automatically set network connection by activating DHCP client .
Once activated, the device automatically connects to the network.
Figure .: Settings section – screen
Figure .: Settings section – screen
Advertisement
Table of Contents
