Related Manuals for Pico Macom PFAP550MS
Summary of Contents for Pico Macom PFAP550MS
- Page 1 PFAP550MS 806MHz Sub-Band Extended Agile Signal Processor Installation and Operation Manual Operation www.picomacom.com Ph:800-421-6511 Manual Rev. 05/03...
- Page 2 To insure proper installation and operation, take a moment to read this guide before proceeding with the installation. If you have any questions or comments about the PFAP550MS digital signal processor, please contact your dealer or have him contact the PICO MACOM Service Center at these phone numbers: 800-421-6511, 818-493-4300.
- Page 3 21. Outdoor Antenna Grounding: Before attempting to install this product, be sure the antenna or cable system is grounded so as to PFAP550MS provide some protection against voltage surges and built-up static charges.
- Page 4 In the event of power failure, the microprocessor’s non-volatile memory preserves input and output channel identification guarantee- ing proper reset when power is restored. The PFAP550MS’s high frequency and extremely high accuracy phase-locked-loop oscillators enable the unit to meet the frequency offset and stability requirements of FCC Docket 21006.
-
Page 5: Specifications
PFAP550MS PFAP550MS 806MHz Sub-Band Extended Agile Signal Processor POWER AURAL ADJUST RF OUT Input Frequency: 5.75-806 MHz Input Channels: CATV T7 to 125 (HRC, IRC) 14-69 Output Frequency: 54-550 MHz Output Channels: CATV 2 to 78 (HRC, IRC) Maximum Output: 57 dBmV min. -
Page 6: Front And Rear Panels
Operation and Controls PFAP550MS PFAP550MS 806MHz Sub-Band Extended Agile Signal Processor POWER RF OUT Front and Rear Panels POWER: Indicates power is on when lit. AURAL ADJUST: Use to set level of audio carrier (volume). Channel display: Displays input and output channels, channel mode, and fine tune frequency increments. -
Page 7: Installation Procedure
TV should be 10 dBmV. MOUNTING: Install chassis in equipment rack (equipment rack sold sep- arately) by supporting the bottom and rear of PFAP550MS at the desired elevation in rack. Line up the side holes of chassis with the tapped equip- ment rack holes. -
Page 8: Limited Warranty
We will issue an invoice for the List Price of the loaner unit plus shipping costs. When you receive the loaner unit, pack the failed unit in the loaner unit’s box and ship it freight prepaid to Pico Macom for repair. When you receive the repaired unit, a new RMA number will be provided in the box. Carefully pack the loaner unit and affix the new RMA number on the box and ship it back to us for full credit excluding shipping costs.
Need help?
Do you have a question about the PFAP550MS and is the answer not in the manual?
Questions and answers