Hanging The Fan - Hunter Anslee 50231 Installation Manual

1886
Hunter Pro Tip:
Pass all wires to one side of horizontal
bar in downrod assembly. Hand tighten
the downrod (at least 4–5 full turns)
until it stops. Trim the wires coming
from the fan so that 8-inches remain
coming from the top of the downrod.
5
Ceiling Bracket Downrod
Installing the Downrod
The ground wire attached to the
downrod is approximately 8 inches.
Hanging Fan
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.

Hanging the Fan

Wiring Canopy
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
WARNING
NOTICE
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
Place the downrod ball into
the slot in the ceiling bracket.
Blades Light Glass/Bulbs