Installing The Ceiling Bracket - Hunter Anslee 50231 Installation Manual

You have two options for installation. Pick which one works best for your location. Remove any existing
bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan's box.
Do this first!
To avoid possible electrical shock, before
installing your fan, disconnect the power by
OFF
turning off the circuit breakers to the outlet
box associated with the wall switch location.
Option 1:
Machine Screws
Use machine screws
(provided with outlet box)
and washers when securing
to existing ceiling fan-rated
outlet box. Make sure it is
securely installed and is
acceptable for fan support of
31.8 kg (70 lbs) or less.
For angled ceilings,
point opening
toward peak.
Follow below if you are using the downrod that came pre-assembled in your box. Need to
install a longer or shorter downrod? Check out the guide at the end of this manual.
Remove the pre-installed
setscrew so that the
downrod can be inserted.
Ceiling Bracket Downrod

Installing the Ceiling Bracket

WARNING
Installing the Downrod
Place the upper motor cover
on the top of the fan.
Hanging Fan Wiring
Option 2:
Wood Screws
Use wood screws and
washers (included) when
securing to support structure
with approved electrical
outlet box. Drill 9/64" pilot
holes in support structure
to aid in securing ceiling
bracket with hardware found
in the hardware bag.
Canopy Blades
Hunter Pro Tip:
The machine screws are the ones
that came with your outlet box.
Washer
bag
Wood Screw
Top Housing
Screw
bag
Align the notches in the upper motor cover
with the tabs on the motor adapter. Insert
the upper motor screws, found in the
hardware bag, and tighten them securely.
Light Glass/Bulbs
1886
x2
x2
3 of 3
4