Table of Contents
Advertisement
EN 10
5.
LC03E MV AA
5. Service Modes, Error Codes, and Fault Finding
5.1
ICONN Switch
Check the position of the ICONN switch if Mirror TV does not
respond to the Remote control. See also Annex B of the Mirror
TV Installation guide.
Normally signals from the remote control go directly to the
Mirror TV (left side picture). After rerouting the remote control
signals and installing the connectivity box, remote control
commands have to go via the connectivity box to the Mirror TV
(right side picture).
Figure 5-1
Locate the small hole at the rear side of the Mirror TV as
indicated in the following picture:
Figure 5-2
Use a paperclip or thin screwdriver to (de)press the switch
located behind the small hole. The switch must be put in
position B to reroute the RC commands.
Now the Mirror TV will only operate with the Connectivity box
connected.
For further service modes, error codes, and fault finding
see service manual LC03E 3122 785 14711
Service Modes, Error Codes, and Fault Finding
F_15730_014.eps
270505
F_15730_015.eps
270505
Advertisement
Table of Contents
