Modena WP 1200 FDWH User Manual Book page 33

Problem
There are rust The affected items
stains on are not corrosion
cutlery resistant.
A program was not
run after dishwasher
salt was added.
Traces of salt have
gotten into the wash
cycle
The cap of the salt
container is loose.
Knocking A spray arm is
noise in the knocking against an
dishwasher item in a basket
Rattling noise Items of tableware
in the are loose in the
dishwasher dishwasher.
Knocking This may be caused
noise in the by on-site installation
water pipes or the cross-section
of the piping.
The dishes The dishes were not
are not clean loaded correctly.
The program was not
powerful enough.
Not enough detergent
was dispensed
Items are blocking the
movement of the
spray arms
The filter combination
is not clean or is not
correctly fitted in the
base of wash cabinet.
This may cause the
spray arm jets to get
blocked.
Glassware Combination of soft
look muddy water and too much
detergent
Possible Cause Recommended Action
Avoid washing items that are not corrosion
resistant in the dishwasher
Always run a wash program without any
tableware after adding salt.
Check whether the salt container is properly
closed.
Interrupt the program and rearrange the items
which are obstructing the spray arm.
Interrupt the program and rearrange the items
of tableware
This has no influence on the dishwasher
function. If you are in doubt, contact a
qualified plumber.
See notes in "Loading & unloading your
dishwasher".
Select a more intensive program
Use more detergent, or change your
detergent.
Rearrange the items so that the spray can
rotate freely.
Clean and/or fit the filter correctly. Clean the
spray arm jets.
Use less detergent if you have soft water and
select a shorter cycle to wash the glassware
and to get them clean.
33