Part 6: Troubleshooting - Modena WP 1200 FDWH User Manual Book

PART 6: TROUBLESHOOTING

Before contacting service center, check the following table:
Problem
Dishwasher Fuse blown, or the
doesn't start circuit breaker
tripped.
Power supply is not
turned on.
Error code:E1; Water
pressure is low
Door of dishwasher
not properly closed.
Water not Twisted or trapped
pumped from drain hose.
dishwasher
Filter clogged
Kitchen sink clogged
Suds in the Wrong detergent
tub
Stained tub Detergent with
interior colorant may have
been used
White film on Hard water minerals
inside surface
Possible Cause Recommended Action
Replace fuse or reset the circuit breaker.
Remove any other appliances sharing the
same circuit with the dishwasher.
Make sure the dishwasher is turned on and
the door is closed securely. Make sure the
power cord is properly plugged into the wall
socket.
Check that the water supply is connected
properly and the water is turned on.
Make sure to close the door properly and latch
it.
Check the drain hose.
Check the coarse filter
Check the kitchen sink to make sure it is
draining well. If the problem is the kitchen sink
that is not draining, you may need a plumber
rather than a serviceman for dishwashers.
Use only the dedicated dishwasher detergent
to avoid suds. If suds exist in the washer.
Open the door for 20-30 minutes to allow the
foam to evaporate. If the foam still exists in
the liner. Add 1.5L of water to the liner, close
the dishwasher door and run a forced drain to
drain it with the water. Repeat above
operation until the foam is cleared.
Make sure that the detergent has no colorant
To clean the interior, use a damp sponge with
dishwasher detergent and wear rubber gloves.
Never use any other cleaner than dishwasher
detergent. Otherwise, it may cause foaming or
suds
32