Water Connection - Modena WP 1200 FDWH User Manual Book

Electrical requirements:
Please look at the rating label to know the rating voltage and connect
the dishwasher to the appropriate power supply. Use the required fuse
10 amp, time delay fuse or recommended circuit breaker and provide
separate circuit for this appliance only.
Electrical connection:
Ensure the voltage and frequency of the power source match with the
rating plate. Only insert the plug to an electrical socket that properly
grounded. If the electrical socket is not suitable with the appliance's
plug, replace the socket rather than using an adapters as it could cause
overheating and risk of fire. Ensure that the grounding connection is
proper before using the dishwasher!

Water Connection

Connect the cold water supply hose
to a threaded 3/4 inch connector and
make sure that it is fastened tightly in
place. If the water pipes are new or
have not been used for an extended
period of time, let the water run first
to make sure that the water is clean
and free of dirt. If this precaution is
not taken, there is a risk that the
water inlet get blocked and damage the appliance.
NOTE!
If the supplied hose does not fit your tap, please contact your local
plumbing supply center where adapters are available for purchase.
10