Practice Spraying - WAGNER CONTROL PRO 170 Owner's Manual

prACtICE SprAYInG

Prior to spraying, it is important that you are using the spray tip / spray material combination
i
that it suitable for your spraying job.
Refer to the chart below for a list of recommendations regarding spray tip size, spray material
and pressure settings.
Control pro tIp SElECtIon ChArt
tIp SIzE
h h h
211
h h h
311
h h h
313
h h h
413
h h h
515
h h
517
h
619
SprAY
prESSUrE
The chart above is a general guideline. Refer to coating manufacturer's recommendations for
i
airless sprayer tip sizes as well as guidelines for thinning the product to be sprayed.
The graphics below show the difference between a good spray pattern versus a spray pattern
that is poor or has "tailing", which may be caused by the improper spray tip / spray material
/ spray pressure combination. For further causes of a poor spray problem, refer to the
Troubleshooting section.
GooD SprAY pAttErn
12
Interior stains Exterior solid
stains
Interior and
exterior clears Acryic sealers
Water sealers
h
h
Low - Med Med - High
(setting 1-3) (setting 3-5)
CoAtInGS
Acrylics
Enamels
Polyurethanes
h h
h h
h
Med - High
(setting 3-5)
poor SprAY pAttErn (tAIlInG)
En
Latex primers Oil primers
Interior latex Exterior latex
paints paints
h
h
h
High High
(setting 5) (setting 5)
h
h
h